Electronics Engineer with 6 years of experience in full-cycle hardware development, designing schematics and multi-layer PCBs. Implementation of EMC principles and DFM practices to ensure signal integrity, high manufacturing yield, and cost-effective production.
Electronic Design
Analog and digital circuit design, power electronics, sensor interfaces, and communication protocols.
PCB Design
Multi-layer board design from concept to production-ready Gerbers, including impedance-controlled traces and HDI stackups.
Measurement & Testing
Low-voltage electrical safety inspections, functional testing, oscilloscope-based debugging, and compliance verification.
EMC & Signal Integrity
Design for electromagnetic compliance, power plane separation, and high-speed signal routing best practices.
Simulation & Analysis
Circuit simulation, thermal analysis, and post-layout signal integrity verification.
Manufacturing Documentation
Technical documentation for mass-production, cross-functional collaboration for DFM practices and manufacturing yield improvement.
Hardware Developer
06.2025 – Present- Developed analog front-end interfaces and communication systems (mixed-signal PCB's) for biosignal acquisition devices.
Electronics Design Engineer
05.2024 – 05.2025- Designing electronic devices for the mining industry (in accordance with the ATEX directive).
- Designing radio devices with PCB antennas.
- Performing tests and measurements related to development projects.
Hardware Engineer
02.2023 – 04.2024- Designing I/O modules (PLC systems) used in safety control systems (certified according to IEC 61508).
- Creating test plans and procedures.
- Overseeing or performing functional, environmental and EMC testing required for product qualification.
Electronics Engineer
11.2020 – 01.2023- Developing of the Steering Column Control Module with safety integrity levels up to ASIL-D (SAS).
- Supporting validation team (root cause analysis) and production processes.
Junior Hardware Engineer
04.2019 – 10.2020- Testing electronic devices.
- Creating test reports.
- Designing PCBs (Altium Designer).
- Standards analysis.
Electrical Technician
05.2015 – 03.2019- Running of electronic systems and devices.
- Designing simple PCB's.
AGH University of Science and Technology
Zespół Szkół Łączności
Advanced PCB Design for EMC & Signal Integrity
Układy cyfrowe – montaż, pomiary, eksploatacja
Electrical Safety Inspection – up to 1 kV & Lightning Protection
ergoHOUSE IO Module
STM32 automation controller with 16 isolated I/O and CAN bus
UWB Localization System
Patient location system using UWB anchors and tags
HOME Post
ESP32-C3 IoT mailbox notification module
Atari Cartridges
RP2040-based cartridges for Atari 8-bit consoles
UWB Antennas
Elliptical and cup-shaped UWB monopole antennas (3–8 GHz)
ZX Spectrum Clone Board
Sizif-512 based clone with SMD modernisation